Exposure on film¶
The “exposure triangle” you learned for digital still applies, but film changes two things: the speed corner is fixed for the whole roll, and the safe direction to err depends on the film type.
In short
Exposure
H= scene luminance × aperture × shutter time, judged against the fixed film speed.Everything is counted in stops (factor-of-2 in light). Aperture, shutter and ISO are all just stop scales.
Sunny 16: in bright sun, shutter ≈ 1/ISO at f/16. A whole exposure system with no meter.
Colour negative: meter for the shadows, err toward overexposure. Slide film: meter for the highlights, err toward underexposure. B&W: expose for the shadows, develop for the highlights.
Stops: the only arithmetic you need¶
A stop is a doubling or halving of light. Every control is a stop scale:
Control |
Full stops |
|---|---|
Aperture (f-number) |
f/1.4 · f/2 · f/2.8 · f/4 · f/5.6 · f/8 · f/11 · f/16 · f/22 – each step halves the light (the number is a ratio, so it goes up as light goes down; the sequence is powers of √2). |
Shutter |
1s · 1/2 · 1/4 · 1/8 · 1/15 · 1/30 · 1/60 · 1/125 · 1/250 · 1/500 · 1/1000 – each step halves the time. |
Film speed |
25 · 50 · 100 · 200 · 400 · 800 · 1600 · 3200 – each step doubles sensitivity. |
Because they are the same unit, they trade one-for-one. f/8 at 1/250 passes exactly the same light as f/11 at 1/125 or f/5.6 at 1/500 – pick the pair that gives the depth of field and motion rendering you want. This is the reciprocity of exposure (which very slightly breaks at extreme times – see Reciprocity failure).
Sunny 16¶
The oldest exposure system, and still a good sanity check:
On a sunny day, set the aperture to f/16 and the shutter to 1/ISO. ISO 100 → f/16 at 1/125. ISO 400 → f/16 at 1/500.
Then adjust for the light by opening up:
Light |
Aperture at 1/ISO |
|
|---|---|---|
Snow / bright beach, hard shadows |
f/22 |
Distinct dark shadows with sharp edges |
Bright sun |
f/16 |
Distinct shadows |
Hazy sun |
f/11 |
Soft-edged shadows |
Cloudy-bright |
f/8 |
Barely visible shadows |
Overcast |
f/5.6 |
No shadows |
Open shade / sunset |
f/4 |
Fun fact
Every roll of film used to ship with a paper exposure guide printed with pictures of these lighting conditions, because most cameras had no meter. The film’s exposure latitude – especially colour negative’s generous highlight range – existed partly so that “guess with the paper slip” gave usable results. Modern colour neg still has that latitude; you are just no longer forced to rely on it.
Metering: reflected vs incident¶
A reflected-light meter (the one in your camera) reads light coming off the scene and assumes it averages to a mid grey (~18% reflectance, or on some meters ~12–13%). Point it at something much lighter or darker than mid grey and it will be fooled – snow meters grey (underexposed), a black cat meters grey (overexposed).
An incident meter (handheld, white dome) reads light falling on the subject from the subject’s position. It doesn’t care what colour the subject is. For portraits and controlled light it is more reliable.
A spot meter reads a 1° patch, letting you place a specific tone deliberately – the basis of the Zone System.
Metering by film type¶
Key idea
Meter for the part of the tonal range that the film renders badly, and let the film’s latitude absorb the rest.
Colour negative clips highlights gracefully but gets noisy, grainy and colour-shifted in underexposed shadows → meter the shadows, or just rate the film ⅔–1 stop slower and overexpose. “Expose for the shadows.”
Colour reversal / slide has almost no highlight recovery – a blown highlight is clear film forever – but holds shadows acceptably → meter the highlights, err toward underexposure. Latitude is roughly ±½ stop.
Black-and-white negative behaves like colour neg: expose for the shadows (place them on Zone III–IV), then develop for the highlights to set contrast.
Depth of field and motion – the creative half of the trade¶
The trade you make when swapping aperture for shutter:
Wider aperture (smaller f-number) |
Faster shutter |
|
|---|---|---|
Buys you |
Shallow depth of field, subject isolation, more light for the same time |
Frozen motion, sharp handheld frames |
Costs you |
Only a thin slice in focus; lens aberrations worse wide open |
Needs more light or a faster film; risk of camera shake gone but subject may be dark |
A rough handheld floor: shutter ≥ 1/focal length (1/60 s with a 50 mm lens), faster if you’ve had coffee. This is often what forces the film-speed choice: indoors at f/2, 1/60, you simply need ISO 400 or 800.
Choosing a film speed for the situation¶
Speed |
Typical use |
Trade-off |
|---|---|---|
ISO 50–100 |
Bright daylight, tripod work, landscapes, studio flash, maximum quality |
Useless indoors without a tripod; finest grain, most sharpness, most saturation. |
ISO 200–400 |
General-purpose, travel, street, overcast days |
The sweet spot. Modern ISO 400 colour neg is remarkably clean. If unsure, load 400. |
ISO 800 |
Indoors, dusk, action, latitude to push |
A stop more grain than 400; excellent for available-light and can be pushed to 1600. |
ISO 1600–3200 |
Concerts, night, no-flash interiors |
Big grain, high contrast, thin shadows – often chosen for that gritty look. |
Where to go next
Latitude, contrast and dynamic range – how much exposure error each film really tolerates.
Metering and exposure in practice – incident metering, the Zone System, and practical recipes.
Film speed: ASA, DIN, ISO and EI – the speed number itself.