Black-and-white films, profiled¶
B&W character depends on the developer almost as much as the emulsion – every profile below assumes a standard general-purpose developer (ID-11/D-76 or Xtol) unless noted. See Black-and-white development.
Reading the entries
“Rate at” is a starting exposure index for full shadow detail in a general developer. The manufacturer’s box speed assumes their reference developer and contrast; real-world shooters very often rate traditional films ⅓–⅔ stop slower.
Ilford HP5 Plus¶
Speed |
ISO 400/27° · common EI 250–400, pushes to 1600–3200 |
Grain |
moderate, cubic – “organic” |
Contrast |
moderate, very controllable in development |
Developers |
ID-11/D-76 (classic), DD-X (speed + smoothness), Microphen (push), Rodinal (grit), HC-110 (convenience) |
The malleable documentary standard. Flatter and more forgiving than Tri-X, with enormous latitude – you decide the contrast at the development stage. Handles harsh light, mixed light and gross exposure error. Pushes beautifully: EI 800 is “free”, 1600 is routine, 3200 is usable for reportage.
EI 250 for rich, full-tonality negatives; EI 400 for the classic look; EI 800–1600 pushed for low light.
The default “learn on this” fast B&W film alongside FP4 Plus.
Kodak Tri-X 400 (400TX)¶
Speed |
ISO 400/27° · common EI 250–400, pushes superbly to 1600 (3200 usable) |
Grain |
moderate–coarse, cubic – the reference “film grain” |
Contrast |
medium–high, gutsy blacks, a gentle S-curve |
Developers |
D-76 (classic), HC-110 (Dilution B – a Tri-X institution), Rodinal (max grit), Xtol (finer), Diafine (2-bath, EI 1250) |
The photojournalism film since 1954 (last reformulated 2007). More contrast and “attitude” than HP5 Plus – snappy midtones, deep blacks, a grain structure that reads as authentic and gritty. The push response is legendary: Tri-X at 1600 in HC-110 is a whole genre of photography.
HP5 Plus vs Tri-X: HP5 is the blank canvas; Tri-X arrives with an opinion. Both are correct answers.
Ilford FP4 Plus¶
Speed: ISO 125/22° · EI 80–125 · grain fine (cubic) · contrast medium, glorious highlight roll-off · developers: ID-11 1+1, Perceptol (extra-fine), Rodinal 1+50 (sharp).
The gentle mid-speed classic. Forgiving latitude, smooth gradation, a “rounded” and timeless tonality. Rate EI 100 for the sweet spot. Superb for portraits, still life, landscape on a tripod, and anything where you want calm, non-clinical monochrome. One of the most pleasant films to develop and print.
Kodak T-Max 100 (100TMX) / Ektapan 100¶
Speed: ISO 100/21° · EI 100 · grain extremely fine (RMS ~8, tabular) · contrast medium, long straight line · developers: T-Max Dev, Xtol, D-76 1+1 (needs consistency).
Since 2025 Eastman Kodak sells this emulsion directly as Ektapan 100 (the T-Max name stayed with Kodak Alaris); same film. The sharpest, finest-grained, widest-tonal-range 100-speed B&W film, clinical, modern, enormous dynamic range. Rewards careful, consistent technique (tabular grain is sensitive to time/temp/agitation). The film for maximum detail: landscape, architecture, reproduction, big enlargements.
T-Max 100 vs Delta 100: T-Max is a touch sharper and more neutral; Delta a touch smoother and warmer. Very close.
Ilford Delta 100¶
Speed: ISO 100/21° · EI 100 · grain extremely fine (core-shell tabular) · contrast medium · developers: DD-X, ID-11 1+1, Perceptol.
Ilford’s tabular 100: very sharp, very fine grain, with a slightly gentler and “warmer” rendering than T-Max 100 and a bit more tolerance of development variation. Excellent all-round high-detail film.
Kodak T-Max 400 (400TMY-2) / Ektapan 400¶
Speed: ISO 400/27° · EI 400 (pushes to 1600) · grain fine, RMS ~10, the finest of any true 400 B&W (tabular) · contrast medium · developers: Xtol (superb), T-Max Dev, DD-X. Also sold as Ektapan 400 by Eastman Kodak direct.
If you want ISO 400 speed without visible grain, this is the film. Sharp, neutral, wide tonal range, modern rendering – less “classic” than Tri-X/HP5 but technically the best 400. Pushes to 1600 more cleanly than the cubic films (though with less of the “character” some want from a push).
Ilford Delta 400¶
Speed: ISO 400/27° · EI 400 · grain fine (tabular) · contrast medium, gentle curve · developers: DD-X, ID-11 1+1, Xtol.
Tabular 400 with a softer, more forgiving curve than T-Max 400 – finer grain than HP5 Plus, more latitude feel than T-Max. A modern all-rounder that splits the difference.
Kentmere Pan 100 / 200 / 400¶
Speed: ISO 100 / 200 / 400 · EI 100 / 100–200 / 200–400 · grain moderate (100) to moderate–coarse (400) · contrast medium–high · developers: ID-11, Ilfotec HC, Rodinal.
Harman’s budget B&W line – simpler single-emulsion coatings, same factory as Ilford. Honest, a little contrastier than the Ilford films, no special tricks. Kentmere Pan 400 pushed to 800–1600 is a genuinely good cheap reportage option. Rate the 400 at EI 200 for full shadows, EI 320–400 for contrast. Outstanding value.
Fomapan 100 / 200 / 400¶
Speeds |
ISO 100 (EI 64–80) · ISO 200 (EI 125–200) · ISO 400 (EI 200–320) |
Grain |
moderate (100), fine-ish (200, part-tabular), coarse (400) |
Contrast |
medium, “vintage”, soft shoulders |
Developers |
ID-11/D-76, Rodinal, Fomadon; the 200 loves Xtol |
Old-recipe Czech cubic-grain films (the 200 is Foma’s one modern part-tabular emulsion and arguably the pick of the three). Characterful, slightly dusty tonality, inexpensive, with looser consistency than Kodak/Ilford. Rate the 100 and 400 generously – their box speeds are optimistic and most “Foma is bad” complaints are underexposed shadows; the 200 is closer to its box speed. Fomapan 100 at EI 64 in Rodinal is a lovely, sharp, classic-looking negative.
CineStill BwXX (Kodak Double-X 5222)¶
Speed: ISO 250 (EI 200–250; 500 pushed) · grain moderate–coarse, cubic · contrast medium, “cinematic” · developers: D-76, HC-110, Rodinal (not C-41).
A 1959 motion-picture B&W negative, unchanged, respooled for stills. Classic Hollywood monochrome – think Schindler’s List, Casino Royale flashbacks. Pronounced but pleasing grain, silvery midtones, holds highlights well. A distinctive alternative to Tri-X with a slightly softer, more “movie” quality. Develop in standard B&W chemistry.
Ilford Delta 3200 / Kodak T-Max P3200¶
True (measured ISO) speed |
~ISO 1000 for Delta 3200, ~ISO 800 for T-Max P3200 – they are push films, designed to be rated fast and developed to match |
Shoot at |
EI 1600 (smoother) to 3200 (grittier); 6400–12500 possible |
Grain |
coarse and prominent – the point |
Developers |
DD-X / Microphen (Delta), T-Max Dev / Xtol (P3200) |
Designed to be rated fast and developed to match. Huge grain, high contrast, thin shadows – the classic concert / night-street / available-darkness look. Rate Delta 3200 at EI 1600 for weddings/receptions, 3200 for grit. Don’t expect ISO 3200 shadow detail – expect mood.
Ilford SFX 200 · Rollei Infrared 400¶
SFX 200 – extended red to ~740 nm. Without a filter: a normal, slightly punchy ISO 200 film. With a deep-red (#25/#29) filter, meter ~EI 6–12: light foliage, dark skies, a gentle infrared effect without a true IR film’s handling headaches.
Rollei Infrared 400 – genuine near-IR to ~820 nm on a polyester base. With an R72 (720 nm) filter, meter EI 6–12: full “Wood effect” – white trees, black skies, haze cut. Load and unload in total darkness; use the lens’s IR focus mark or stop down.
See Spectral sensitivity: what colours the film can see and Filters for film.
Ilford Ortho Plus 80 · Rollei Ortho 25 Plus¶
Orthochromatic (red-blind). Without any filter: dark skies, dark lips, ruddy contrasty skin, strong blue/green separation – the “1930s movie close-up” look. Very fine grain, high sharpness. Bonus: develop in a tray under a deep-red safelight and watch the image come up. Rate at box (EI 80 / 25); Ortho Plus is also a favourite for copy and internegative work.
ADOX CMS 20 II¶
Speed: ISO 20 (EI 12–20) · grain effectively none · resolution ~800 lp/mm · requires Adotech IV developer for pictorial contrast (in any other developer it’s a line/copy film).
A documentary/microfilm-grade emulsion tamed into a pictorial film by its dedicated low-contrast developer. The highest-resolution film you can shoot – a 35 mm frame approaches medium-format detail. Demands a tripod, precise exposure, and the right developer. A specialist tool, not a daily driver.
Ilford XP2 Super – see Colour negative films, profiled¶
It’s B&W, but it develops in C-41, so its profile lives with the colour films. Short version: dye image, no silver grain, EI 50–800 on one roll, grain improves with overexposure, any 1-hour lab can process it.
Fun fact
The reason a “cheap” film like Kentmere Pan 400 and a “premium” film like Delta 400 come off the same factory floor is that the expensive part of a B&W film is the coating run and the R&D, not the silver. Once Harman is committed to running the line, a simpler emulsion recipe through it costs only a little less to make – the price gap is mostly about product positioning and the multi-layer complexity of the Delta/T-grain films.
Where to go next
Black-and-white development – the developer half of every entry above.
Pushing and pulling film – rating these films off box speed.
Filters for film – coloured filters to shape B&W tone.